Two newly installed routers flooded the FAA’s communications network with connection requests, bringing all U.S. flights to a standstill for more than four hours.
Two newly installed network routers triggered a nationwide ground stop for all flights in the United States on November 13. The Federal Aviation Administration (FAA) imposed the ground stop at 3:54 p.m. Eastern Time (9:54 p.m. Central European Time). It lasted more than four hours. Thousands of flights were canceled or diverted, and reports indicate that the disruption continued to affect air travel on Monday.
Thousands of Connections Every Few Seconds
The problem was first detected at the Indianapolis Center, which oversees airspace over parts of Kentucky, Indiana, Ohio, and West Virginia. Air traffic controllers there could no longer communicate reliably with flight crews.
While investigating the cause, the FAA identified newly installed routers from Juniper, which has been part of HPE since 2025. The devices had been installed at a radio site in El Dorado, Arkansas, and, according to Tom’s Hardware, at a radar site in Amarillo, Texas. The Wall Street Journal reported that defense contractor L3Harris had installed the routers in El Dorado earlier that same day.
“When we started to see the occurrence where our network was having instability, we started to look at what was the cause. And as such, we saw two places that were actually pinging our network at a very high rate — a thousand connections over every four to five seconds.”
Rebecca Guy, FAA Chief Technology Officer
Modern networks would normally handle this traffic without difficulty. However, the FAA’s communications infrastructure still relies largely on decades-old copper lines and was overwhelmed by the volume of data. According to The Wall Street Journal, communications failed at 17 of the FAA’s 22 air traffic control centers. The system only stabilized after the FAA disconnected both routers.
HPE Points to Router Configuration
The FAA identified a specific router feature as the cause of the overload and disabled it across all Juniper routers in the air traffic control network. According to reports, around 60 other Juniper routers in the network continue to operate normally. U.S. Transportation Secretary Sean Duffy said the routers’ ability to transmit data had been disabled. An HPE spokesperson said the routers had not malfunctioned but had operated as configured by the installer. The devices are currently being examined at an L3Harris laboratory in Florida. As of the weekend, the investigation had not established a definitive root cause.
According to FAA Administrator Bryan Bedford, the agency is gradually replacing Cisco routers with Juniper equipment. This is part of its routine operations and is separate from the FAA’s $12.5 billion modernization program, which aims to transition the network to fiber optics. Transportation Secretary Duffy has asked Congress to allocate $50 billion for a comprehensive overhaul of the air traffic control system. In January 2023, an outage affecting the Notice to Air Missions (NOTAM) alert system had already forced a nationwide ground stop across the United States.
(Editorial Team)